The jig used for anodized aluminyo checkered plate is used for anodizing aluminum plate, because the jig and workpiece appearance will quickly generate oxide film during anodizing, and a slight loosening of the jig and workpiece during this process will change the contact orientation and prevent the current flow, for this reason, it is necessary to use a jig with elasticity to clamp the workpiece. Only in this way can the anodizing process be carried out normally.
Layout of fixture
The layout of the fixture is appropriate for individual type, if the assembled type is used, the riveted or welded area will be loosened by corrosion after several applications, preventing the normal flow of current in the anodic oxidation process. Together, the fixture should have a certain cross-sectional area. A fixture with a certain cross-sectional area also has sufficient elasticity and clamping force to keep the workpiece and the fixture in excellent contact and ensure the normal flow of current during the anodizing of the clamped workpiece. Prevent the workpiece from being burned due to the heat generated by poor touching.
Selection of fixture material
The manufacturing fixture is made of rigid aluminum, which is good in elasticity and durable in fastening.
Clamping of workpiece
Here are two small points, which are cleaning and de-filming of the jig and selection of clamping position
To clean the jig and remove the film is in the anodic oxidation process, the jig will also occur in the oxide film. For this reason, it is necessary to remove the oxide film before reusing the used clamps. The film removal can be done in aluminum degreasing solution. This method can also extend the life of the fixture for some fixtures. The selection of clamping position should be usually on the vice side of the workpiece (i.e. non-decorated part). Otherwise, the touching part of the workpiece and the fixture can’t generate the oxide film because it is hidden by the fixture, and of course, it can’t be colored, which will show the obvious white stain and affect the appearance quality. In addition, whether the recessed part of the workpiece suspended in the solution after clamping will occur in the nest gas and other questions should also be considered.
